Winco HPS6000HE/E Betriebsanleitung PDF herunterladen (Seite 5)

3180-00 60706-238

load, such as an air compressor, it will require more

starting current. If it is connected to a light load,

or no load such as a power saw, it will require less

starting current. The exact requirement will also

vary with the brand or design of the motor.

Self-exciting generators respond to severe overload-

ing differently than utility power. When overloaded,

the engine is not able to supply enough power to

bring the electric motor up to operating speed. The

generator responds with high initial starting current,

but the engine speed drops sharply. The overload

may stall the engine. If allowed to operate at very

low speeds, the electric motor starting winding will

burn out in a short time. The generator winding

might also be damaged.

CAUTION: EQUIPMENT DAMAGE

RUNNING THE GENERATOR SET UNDER

THESE CONDITIONS MAY RESULT IN DAMAGE

TO THE GENERATOR STATOR AS WELL AS THE

MOTOR WINDING.

The heavy surge of current required for starting

motors is required for only an instant. The genera-

tor will not be damaged if it can bring the motor up

tospeedinafewsecondsoftime.Ifdifcultyis

experienced in starting motors, turn all other electri-

cal loads off and if possible reduce the load on the

electric motor.

PREPARING THE UNIT

UNPACKING

CAUTION: EQUIPMENT DAMAGE

THIS UNIT HAS BEEN SHIPPED WITHOUT OIL.

Failure to maintain the engine oil at the proper level

will result in serious engine damage.

When you unpack your new engine-generator set be

sure to remove all the information sheets and manu-

als from the carton.

1. This generator-set was in good order when

shipped. Inspect the generator-set promptly after

receiving it. If any damage is noted, notify the trans-

portation company immediately; request proper pro-

ceduresforlinga“concealeddamage”claim.Title

totheequipmentandresponsibilityforlingaclaim

rests with you when a generator set is sent F.O.B.

shippingpoint.Onlyyoucanlegallyleaclaim.

2. Before proceeding with the preparations of your

new generator set for operation, take a couple of

minutes to ensure the unit you have received is the

correctmodelandreviewthespecicationpagesin

this manual to insure that this unit meets your job

requirements.

LUBRICATION

Beforestartingtheengine,llthecrankcasetothe

proper level with a good quality oil. The recom-

mended grade of oil and quantity of oil required is

listed in the engine operator’s manual and below in

this manual. This unit was shipped with most of the

oil removed. The engine normally holds 38 to 39

ounces of oil. Since there is some trapped oil in the

engine,whenllingthecrankcasethersttimeuse

thedipsticktoensurethatyoudonotoverllthe

crankcase. The blow-up shows the full oil level mark

on the dipstick.

Oilisaddedtotheenginebyremovingtheoilllcap

andaddingoilatthispoint.Afterllingthecrank-

case to the proper level, be sure you properly tighten

theoilllcap.NOTE:Thisenginegeneratormust

be on a level surface before you check or add oil to

the system.

The necessity of using the correct oil, and keeping

the crankcase full cannot be overemphasized. En-

gine failures resulting from inadequate or improper

lubricant are considered abuse and not covered by

the generator or engine manufacturer’s warranty.

Oil Recommendations

Outdoor temperatures determine the proper oil

viscosity for the engines. Use the chart to select the

best viscosity for the outdoor temperature range

expected.

ENGLISH

REDUCTION CASE OIL (applicable types)

Recommended Oil

Oil Level Check

2 : 1 Reduction Case With Centrifugal Clutch

Oil Change

WASHER

OIL LEVEL

DRAIN PLUG

OIL FILLER CAP/

DIPSTICK

UPPER LIMIT

OIL FILLER CAP/DIPSTICK

LOWER LIMIT

OIL FILL HOLE

(bottom edge)

LOWER LIMIT

UPPER LIMIT

OIL FILLER CAP/DIPSTICK

Install the oil filler cap/dipstick and tighten securely.

Use the sameoil that is recommendedfor the engine (see page ).

Check the reduction case oil level with the engine stopped and ina

level position.

Remove the oil filler cap/dipstick and wipe it clean.

Insert and remove the oil filler cap/dipstick withoutscrewing it

into the filler hole. Check the oil level shownon the oil filler cap/

dipstick.

If the oil level is low, add the recommended oil to reach the

upper limit mark onthe dipstick.

Screw in the oil filler cap/dipstick and tighten securely.

Check the engine oil level with the engine stopped and ina level

position.

Remove the oil filler cap/dipstick and wipe it clean.

Insert the oil filler cap/dipstick into the oil filler neck as shown,

but do not screwit in, thenremove it to check the oil level.

Reinstall the oil filler cap/dipstick.

If the oil level is near or belowthe lower limit mark on the

dipstick, fill withthe recommended oil (see page ) to the

upper limit mark (bottom edge of the oil fill hole). Do not overfill.

Running the engine with a low oil level can cause engine damage.

This type of damage is notcovered by the

Distributor’s Limited

Warranty.

The Oil Alert system (applicable types) will automatically stop

the engine before the oil level falls below the safe limit.

However, to avoid the inconvenience of an unexpected

shutdown, fill to the upper limit, and check the oil level regularly.

Running the engine with a low oil level can cause engine

damage. This type of damage is not covered bythe

Distributor’s

Limited Warranty.

With the engine in a level position, fill with the recommended oil

(see page ) tothe upper limit mark (bottom edge of the oil fill

hole) on the dipstick.

Please dispose of usedmotoroil ina manner that is compatible

with the environment. We suggest youtake used oil in a sealed

container to your local recycling center or service stationfor

reclamation. Do not throwit inthe trash, pour it on the ground,

or pour it down a drain.

Allow the used oil to drain completely, then reinstall the oil drain

plug and new washer, and tighten the oil drain plug securely.

Place a suitable container belowthe engine to catch the usedoil,

then remove the oil filler cap/dipstick, oil drain plug and washer.

Drain the usedoil when the engine is warm. Warmoil drains

quickly and completely.

The Oil Alert system (applicable types) will automatically stop the

engine before the oil level falls below the safe limit. However, to

avoid the inconvenience of an unexpected shutdown, always

check the engine oil level before startup.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Winco HPS6000HE/E Betriebsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Stromgeneratoren Winco HPS6000HE/E